>Hi Jim
>
>Just a couple of suggestions
>
>1) Put a wait state as the very first line in your startup program, eg =INKEY(0). Then run the exe. If it still happens then you know it has nothing to do with your code since your code has not run yet. Then I would suspect the problem might be with the VFP dll and runtime engine.
>
>2) Is the exe compressed? If so re-compile without it.
>
>3) Is the exe encrypted? If so ditto.
>
>Clearly this is not a code issue but something that happens after you compile it and therefore are using different dll. Cannot be a memory thing either. I think the memory issue is a symptom of another problem.
>
>HTH
>
>Jos
****************
Since it appears that no solution was found in this thread, I am going to add another idea. Today I got the "insufficient memory" error when I started foxpro in development mode. My other posts were about the message in run-time mode. This time I had just made several changes in the config.fpw. Since that is the only change I had made, I deleted the file and the error went away. So my suggestion is to look at a problem in the config.fpw.