General information
Category:
Reports & Report designer
>In FoxPro 2.6 I was able to create groups that where 10 (or more) inches tall (basiclly a FULL page), however, when I brought the report into VFP 6, VFP complained that the groups were too large to fit the paper.
>
>I've shrunk the groups to about 9 inches but I really need them to be larger.
>
>Any Ideas????
Make sure that you set the Print Area to Whole Page, not Printable Page. That's in the Page Setup dialog available through the File menu.
Tamar
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only