General information
Category:
Reports & Report designer
>That would give irregularities if you SET ORDER TO in an existing table, a SET FILTER, or, in some cases, a query without NOFILTER. The wizard-generated report uses a report variable instead (incremented by 1 for each record); otherwise, it uses the same basic idea: Variable % 2 = 1
>
>Hilmar.
You are very correct. I had not thought of this. I usually put the records I want into a cursor. Then display that in the report. I never use filters. So I forgot about their affect. Glad you were paying attention to my post.
Mike
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only