General information
Category:
Reports & Report designer
Hi Steve
Thank you for tips.
I have a question
I try to put a Command button over the viewer of crystal report
but even if I change the zorder of the viewer my button stil under the viewer any tips ?
Thank again
Ben
>Ben,
>
>The reason I use the CR Main Report control (OCX file) is because I develop the Crystal Report first in Crystal so it can run stand-alone in Crystal with paramters. Then, I add the code to my VFP form to run the Crystal Report, that way, I can have my cake and eat it too. You can run Crystal Reports with or without VFP interface.
>
>I do not use the RDC yet because I am converting existing Crystal Reports in most cases. I have been told to use the RDC if creating a new Crystal Report from scratch, but have not done so. I am not familiar with the RDC, although I have studied it some.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only