General information
Category:
ActiveX controls in VFP
The only way I could find to do it was to keep track of the currently selected node (or figure it out at nodeclick time), and if the clicked node is to be 'disabled', set the treeview's selecteditem back to the currently selected node.
It isn't as clean as I'd like because there is a bit of a cursor flip, but in general it works ok.
Alan
>Hi, everybody
>
>Is there any way to disable a specific node in a Treeview, or to blockade the user acess to it?I´d like to show the node to the user but not to allow the acess to it.
>
>TIA
>
>Moacyr
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only