Hi,

This is off the subject slightly. I've known about the draw capability in VFP for quite a while, but I've always wondered, when you draw something like this in VFP, how do you print it?

I've thought about modeling software written in VFP (using draw) but I see no obvious printing solution.

Guy



>Hi Albert, glad it works for you.
>
>Just fyi - instead of all the .Line commands you could also use the .Box command. However, I prefer .Line commands because I can then either (a) not draw a particular line at all and/or (b) draw only a part of the line.
>
>I could use these two options in order to not draw lines which would not be visible in the case of a solid cube. In this way I would reduce the "optical illusion" effect of the "see-thru" cuboid.
>
>
>
>>Hi Jos !
>>
>>Your answer helps a lot.
>>Thank you very much !
>>
>>Best regards
>>Albert