General information
Category:
Reports & Report designer
Gil,
Have you had any more dialog concerning the alignment issues. Thanks in advance.
Jamie
>>I have an application that prints data on a pre-printed insurance form (UB92). Though the alignment is fine at one location / printer it is "off a bit" at another location. I cannot simply move the fields in the report because I need the report to be correct universally. Is there a way I can prompt the user (and store the data) to enter +/- beginning margins (top/left) and have the form adjust according to these parameters. Thanks in advance...
>>
>>
>>Jamie Flick
>>Micro League Software
>
>Jamie,
>I'm interested in a reply to this as well. As far as I know there is no easy way. I've always just assumed the that alignment was to a specific printer driver and printer model. Most of the time it was basically printed fields that had to be lengthened, if possible. The vertical positioning has usually never been a problem.
>I do have one customer where I have excluded a report (with very tight requirements) from the app and each user has the app running locally from their C Drive. The app looks for the report form in the relative location of "\Reports". There are two different HP models that run the same report and I have a different report (but the same name) from specifically aligned for the printer the user uses. I know this is klunky but it works.
>There is probably some one out there that has created a utility that uses the FRX and infrements the vpos and/or hpos values.
>Again I'd like to see it too.
>
>Good Luck
>
>-Gil
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only