Jay Johengen
Altamahaw-Ossipee, Caroline du Nord, États-Unis
Information générale
Titre:
Execute Code if Value Changes in Debugger
Is there a way to list/print/display the line number of code or run a procedure if a value changes during execution? I need to determine exactly when SET('SAFETY') changes from the beginning of the application to a certain point. Tracing jumps around too much and only shows you the line following the change, not helpful especially when routing through classes and such. And the call stack is not always helpful in this case either when it is sitting on a READ EVENTS.
Regards, Renoir
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement