General information
Category:
Installation, Setup and Configuration
Title:
Setup Wizard Error 240 & Location Destination
I am trying to distribute a VFP 3.0 application. I have run into a couple of problems. First is that after completing the wizard I attempt to run the program and I get a Setup Wizard Error 240 your setup files may be corrupted.
I have search for the cause of this and I have found several errors on Setup Wizard Error 278. I have tried the few solutions found there. Namely removing the dkcontrol.*, removing links to icons within the distribution tree, and reinstalling VFP 3.0b.
So if there are any known answer for the Setup Wizard Error 240, I would be appreciative.
2nd, I need to give create the distribution so that the default installation drive is D, It takes D, but when I run the setup.exe, it is on C.
Any ideas on this would be greatly appreciative as well.
3rd, I have two icons a 16x16 and a 32x32, however when I attach either icon to the application exe, I only get that icon. I mean If it is the 32x32, the icon show up only when I am looking at large icons, if I am looking at list or detail I get the fox icon. The symptons are reversed if I attach the 16x16, this is a showstopper but it is very unprofessional. Any suggestions
Much Thanks
:-)
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only