General information
Category:
Coding, syntax & commands
When you change a Grid's RecordSource this is what you get. In the time between disconnecting RecordSource 1 and conecting RecordSource 2 the grid gets all discombobulated and forgets all about itself.
If the Grid id based on a view you don't get this sproblem... There are other ways that work too but, offhand, this is what I remember <s>.
>---------------------------------------
>I run a form, send a query to a grid and refresh. The first time through, the grid comes up with properties properly set. When I try to run the query again something resets all the grid properties to none or 0....
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only