General information
Category:
Coding, syntax & commands
Hi Garrett,
>I'm fairly certain this is design behavior, and makes a certain amount of sense, if you think about it from a heads-down-entry point of view.
I do not share this opinion completely.
If i put a memo with two or more lines, and resize EditBox Height,
the mode to operate way changes; ok i control Height and no go on this situation.
The problem is still the same: where is document this behaviour ?
FWIW, SHIFT+ENTER always adds a line feed instead of going to the next control.
The problem is still the same: where is document this behaviour ?
You can found SHIFT+ENTER shortkey on VFP Help ?
Fabio
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only