>Since a while, my Hewlett Packard ScanJet 6300C takes about five minutes to scan. It is obvious that since a specific time a conflict is now present which would cause such reaction. Basically, I put the paper in. Then, I press scan and I can hear it to start its first phase. Then, it waits for a few minutes. I hear again some progress. Then, I wait about two more minutes. Then, it starts scanning and it works. Could it be that since I installed the Dazzle reader that this would have been in effect? I'd say it's about the same timeframe.
Be sure your DPI hasn't been cranked up to some unneeded value. The higher the dpi the longer the scan.
I havent been in this forum for a while, sorry,
~Joe Johnston USA
"If ye love wealth better than liberty, the tranquility of servitude better than the animated contest of freedom, go home from us in peace. We ask not your counsel or arms. Crouch down and lick the hands which feed you. May your chains set lightly upon you, and may posterity forget that ye were our countrymen."
~Samuel Adams
