Information générale
Catégorie:
Gestionnaire de rapports & Rapports
Yeah, I had just noticed that - we should have thought of that earlier. I saw that a CHR(27)+CHR(64) followed immediately by the below ignored the I-Prime command. Allowing a 2 second delay made it work OK. It was then I noticed the spooler popping up - Windows being once again too helpful. So much for 'print direct to printer'. Sigh. Glad you have it done.
>Thanks Jim, sending all of the codes in one shot instead of in separate ??? commands worked. It finally is working on all of the 3 forms that were exhibiting problems. Wish I had thought of that!
>
>Tracy
>
>>Tracy, try a CHR(27)+CHR(125)+CHR(0) as a replacement for your 'reset'. If the I-Prime is at default, the buffer finishes printing, and the pitch and quality go to power on defaults.
Précédent
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement