General information
Category:
ActiveX controls in VFP
Hi Randy,
Are you still in the position that it runs fine under Win2k in your laptop but not under XP in other hardware? Just looking to see what we can eliminate.
A framing error is basically a timing problem - the stop bit was not detected when/where it should have been. Causes - mismatched settings, noise on the wire, serious clock problems on either end, marginal signal levels.
Have you tried viewing the data in Hyper Terminal? How about my file#19165? Any differences?
>Well I have pretty much started over on this and it looks a little better. I am not consistently getting the correct data, but at least I am getting some data. I guess my big question is what is the framing error. I receive this when getting input from the scale. I still have data in the input buffer, so I am almost satisfied, but I would like to know more about this framing error. Thanks for the help.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only