>>Occasionnaly, when a prg contains an error, it seems to stay opened even if I cancel, close all, clear all, set proc to...
>>
>>The only way I found is to close and re-start VFP.
>>
>>Any ideas?
>>
>>TIA
>
>Mario,
>Is the error within a DO WHILE ... ENDDO loop? I had a similar problem in a constant loop where I had CANCEL within the loop. I could not recompile the exe and found that, using Windows NT task manager, there was still a process active for the exe!! I had to end the process to release the exe! I changed the CANCEL to EXIT and it never happened again. There was no button on the task bar but there WAS an entry in the process list.
===
In fact, yes, in this case, my programs stop (because of an error) in the middle of a Do While loop. however, I can't do EXIT, because I'm at the command window ands EXIT can only be used in programs.
This close/reload of VFP is really time consuming.
Any other suggestions?
Précédent
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement