General information
Category:
Installation, Setup and Configuration
I haven't found anything in the readme file that refer to the command prompt, but that led me to find a readme file where it was mentionned to install Windows Component Update before starting the setup. I ran the setup from the WCU subfolder and then I was able to run the setup of VFP 8.0.
I don't know what was the problem, but at least I now have VFP 8.0 installed :-)
Thanks for your help George.
>Have you tried running it from the command prompt? There's a switch that you can pass for it to bypass the prerequisites. It's listed in the read me file, I believe.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only