General information
Category:
Forms & Form designer
You could reduce the problem (I think), though not eliminate it. If you set up a data grouping where the group only ever contained one detail record (if no other possibility you could use recno("table")). That would give you a group header and footer for each detail record. Forget the detail band and split the fields between the two group bands. That way you should get only half the lost space per page. I havn't had chance to test this so I can't guarantee it will work.
Best regards
Andrew
>Thanks Andrew,
>
>I have already done those things. The lines that are blank are actually not printing, and there is no space left for them. The part of the report that prints on and individual page is exactly what I want. My problem seems to be that when there is not enough space left on the page to contain a full detail band for the next record assuming that all the lines will be full, FoxPro ejects to the next page for that detail item. Regardless of the amount of data that is really in that detail record. I would like the decision to be based on what is really going to print.
>
>I could accept the detail band not being preserved on a single page as that would be a better solution than what I am getting now.
>
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only